3) Insert the carbon filter in the
rectangular hole, fitting it over the
motor.
IMPORTANT: The cutaway
(indicated by the arrow) must be
located at the front right of the
rectangular hole.
4) After inserting the front edge of
the carbon filter into the slot on the
cooker hood. Lower the back edge of
the carbon filter, until it clicks into
place at the rear of the rectangular
hole. Raise the two fixing bars, until
they are horizontal over the carbon
filter.
5) Care should be taken to ensure that the cable from the main body
of the cooker hood to the lights is positioned in the cutaway.
6) Reattach the light fixing to the main body of the cooker hood.
7) Refit the grease filters.
o The carbon filters should be replaced approximately every three
months, if they show signs of damage, or if you start to notice
that cooking smells are entering the kitchen through the upper
vents.
14
To Next Page
Loading...
