Using your Baumatic ice cream maker
Before switching on
o Make sure that it has been installed by a suitably qualified
person, as per the information contained in Baumatic’s
installation instructions.
o After delivery, wait for a couple of hours before connecting the
appliance to your mains supply. This will allow any oil from the
compressor that may have been disturbed during the
transportation process to settle.
o The outside of the appliance and the removable accessories
contained within it, should be cleaned with a solution of liquid
detergent and water.
o The interior of the appliance should be cleaned
with a solution of sodium bicarbonate dissolved in
lukewarm water. The interior and accessories
should be thoroughly dried, after the cleaning
process has been completed.
o There can be an odour when you first switch on the appliance. It
will lessen when the appliance is used.
Prior to making ice cream
o Your appliance MUST be placed on a flat surface, to ensure that
the built in compressor operates properly.
o The appliance MUST have 20 cm of space each side of it and the
ventilation slot should not be obstructed.
o IMPORTANT: The appliance MUST NOT be connected to your
mains supply until all of the steps below have been followed.
o Thoroughly wash all parts of the appliance that will come into
contact with ingredients and ice cream (including the fixed bowl,
removable bowl, mixing arm and transparent cover).
o Prepare the required recipe ingredients, by following your own
recipe or from one contained in this user manual.
o Place the prepared ingredients into the removable bowl.
IMPORTANT: There is no need to freeze the ingredients prior to
placing them inside the ice cream maker. The appliance has a
built in compressor which will do this.
8
To Next Page