o Unscrew the injector (B) and replace it
with the stipulated injector for the new gas
supply (see table below).
o Reassemble all the burners carefully; in particular you should
make sure that the flame spreader is correctly placed on the
burner.
Gas tap maintenance
These maintenance operations MUST ONLY be
carried out by a CORGI registered engineer.
IMPORTANT: Before carrying out any maintenance operations,
disconnect the appliance from the gas and electricity supplies.
If a gas tap becomes stiff to operate, then you should proceed as
follows:
o Remove the control knobs, pan supports, burners, hob fixing
screws and clamps.
o Remove the hob from the worktop and remove any underside
protective covers.
o Disconnect the fixings holding the tap to the fascia panel and
separate the assembly. Then clean the cone and seating, with
a cloth dampened with solvent.
To Next Page
