What to do if all 3 LEDs flash red on Baumer Industrial Equipment ULT 400 XL?
If all 3 LEDs are flashing red on your Baumer Industrial Equipment ULT 400 XL, it indicates a hardware error within the sensor. Check the user interface for a specific error message. You may need to replace the sensor.
Why Baumer hhs ULT 400 XL ULT 400 XL sensor does not detect any adhesive?
If the Baumer Industrial Equipment ULT 400 XL sensor isn't detecting adhesive, begin by verifying the sensor's installation. Ensure that the infrared measurement technology window is clean; if dirty, gently clean it with a soft cloth. Also, check the sensor setup on the system controller to ensure it's correctly configured. Finally, review the product and adhesive detection sensitivity settings to confirm they are programmed correctly.
General| Brand | Baumer |
|---|---|
| Model | hhs ULT 400 XL |
| Category | Industrial Equipment |
| Language | English |
Overview of the ULT 400 XL sensor and its purpose as an adhesive monitor.
Guidelines for using the manual and reporting hazardous situations.
Details on electrical parts, warranty, liability, and customer service.
Information on related documents, copyright, and usage restrictions.
General overview and item number for the ULT 400 XL sensor.
Explanation of symbols and signal words used for safety guidelines.
Specific safety instructions, helpful tips, and labels used in the manual.
Defines intended use, foreseeable misuse, safety devices, and work area hazards.
Covers safety markings, securing against restart, and owner's obligations.
Defines obligations for operating companies and integrators for safe operation.
Covers accident measures, personnel qualifications, and personal protective equipment.
Detailed safety guidelines for various stages of the product lifecycle.
Information on safety when using replacement parts and warranty implications.
Specific safety guidelines and risks associated with the ULT 400 XL sensor.
Details the sensor's function, minimum detection size, and physical structure.
Explains LED status indicators, programming, and regular operation modes.
Guidelines for receiving, inspecting, and storing the product packages.
Instructions for disposing of packaging materials and environmental risks.
Steps for sensor installation, including personnel, equipment, and safety precautions.
Details on connecting the sensor electrically and integrating it into the system.
Preparing test materials and understanding regulatory requirements for commissioning.
Steps for commissioning the sensor and configuring system settings.
How to operate the sensor, including software control and configuration.
Procedures for sensor programming and understanding regular operation status.
Guidelines for routine maintenance and cleaning of the sensor.
Precautions to avoid property damage during sensor cleaning.
Guidelines for identifying and conducting fault elimination safely.
Specific troubleshooting steps for sensor detection and LED fault indicators.
Procedures for disposing of electronic waste according to regulations.
Guidance on component disposal and minimizing environmental impact.
Detailed dimensions and operating specifications for the ULT 400 XL sensor.
Information on the sensor's protection class and environmental operating conditions.
Identification of wearing parts and available connection cables for the sensor.
Details on available extension cables for extending sensor reach.
To Next Page
