panel upwards.
You may elect to remove the rubber gasket from the rear-most edge of the
panel at this point, as it will allow easier removal of the panel. Simply slide the
gasket toward you by firmly pulling on it using your hands.
8. It’s time to remove the driver side carpeted panel at this point. Using your
hands, free the panel from the edge of the trunk as shown in the photo, and pull
the panel inward toward the center of the vehicle. Once you’re at this point, pull
the trunk liner outward towards the exit of the trunk.
9. With the panel removed, you will see the factory amplifier and all of the
associated wiring harnesses shown below:
To Next Page
Loading...