Bazooka FAST-9999 User Manual

How to install the FAST-9999 with the FAST-BTAH
The FAST-9999 universal harness uses the patented Posi-Tap connector from Posi-Products for making
FAST secure connections to your OEM wire harness.
Posi-Tap TM Patent # 5,228,875 5,695369 5,868,589 6,692,313 Jap 2881414, Aus 708700, Tia 103534, Can 2204826
Mex 200626 Korea 477279, China Z197105562.9 & others pending
Disconnect negative battery clamp from battery.
For easiest installation remove the radio and disconnect
the harness from the back of the radio.
Connect the Posi-Tap connectors to the corresponding
wires of your radio harness. Consult your car or radio
manufacturer’s manual to get the correct color codes
for your vehicle.
Red
(+) 12V Power. Turns on when ignition/accessory is on.
Blue/White Turns on remote accessories (amplifiers, etc.).
If there is no Remote Amplifier wire, you can often use the
power antenna wire.
White (+) Left Front Speaker
White/Black (-) Left Front Speaker
Gray (+) Right Front Speaker
Gray/Black (-) Right Front Speaker
Make sure the end with the 6 pin Molex connectors is
toward the radio. Run the BTAH harness behind radio,
dash and along the edge of the vehicle until you get
to the place you have decided to mount the tube.
Continue to thread until the cap
is tight and the wire is pierced.
Make sure to attach all 6 of the
FAST-9999 harness wires to
your OEM harness.
Plug the FAST-9999 harness into
the FAST-BTAH. Mount grounding
ring and plug the 14 pin connector
into the BASS TUBE. For more information
on placement and mounting, consult
your amplified tube instruction manual.
FAST-9999
14 pin connector
to the BAZOOKA
Ground to
chassis of
vehicle
FAST-BTAH
Remove the top cap. Place the wire
that is going to be tapped. In the
grove of the cap as far down as it
will go.
Make sure not to cross thread the
cap when screwing it back in place.

Bazooka FAST-9999 Specifications

General

Brand	Bazooka
Model	FAST-9999
Category	Cables and connectors
Language	English

Summary

Installation Preparation and Safety

Disconnecting Battery and Radio

Disconnect the negative battery clamp and remove the radio for installation access.

FAST-9999 Harness Overview

Introduction to the FAST-9999 universal harness and its Posi-Tap connectors for secure connections.

Wiring Identification and Connection

OEM Wire Color Identification

Guides users on identifying power, remote, and speaker wires by color for proper connections.

Posi-Tap Connector Usage

Detailed steps on how to correctly use Posi-Tap connectors for secure wire tapping.

Connecting All Harness Wires

Ensures all six wires from the FAST-9999 harness are attached to the vehicle's OEM harness.

Harness Routing and Final Assembly

Routing the BTAH Harness

Instructions for routing the BTAH harness behind the dash and along the vehicle edge.

Final Connections to Bass Tube

Plugging the FAST-9999 into FAST-BTAH and the 14-pin connector into the BASS TUBE.

Grounding and Mounting Guidance

Mounting the grounding ring and consulting the amplified tube manual for placement.