bca FLOAT Instructions

Backcountry Access, Inc.
www.backcountryaccess.com
External Shovel Carry Attachment Instructions
FLOAT
b
a
a
a
1. Start with pack facing up. Lay the shovel carry accessory on top, also facing up.
2. Insert each of the three strap buckles onto loops on the pack. Loop the webbing back through the
buckles and tighten.
3. Slide the shovel blade between the accessory’s two pieces of fabric.
4. Take the webbing at the top of the accessory, pass it over the top of the shovel blade and through
one of the daisy chain loops. Slide on the open ended hook to secure the shovel.
Accessory can be used to secure shovel with or without shaft attached.
WARNING : Ensure all connections between the pack and the shovel attachment are secure before
each use. Shovel should be snug and top hook engaged to ensure the shovel does not
release from attachment.
WARNING : Ensure all connections between the pack and the shovel attachment are secure before
each use. Shovel should be snug and top hook engaged to ensure the shovel does not
release from attachment.
WARNING : Ensure all connections between the pack and the shovel attachment are secure before
each use. Shovel should be snug and top hook engaged to ensure the shovel does not
release from attachment.
WARNING: Ensure all connections between the pack and shovel attachment
are secure before each use. Shovel should be snug and top hook
engaged to ensure the shovel does not release from attachment.

bca FLOAT Specifications

General

Brand	bca
Model	FLOAT
Category	Security Sensors
Language	English