Pg. 8
PRODUCT ASSEMBLY
Remove the nuts/washers from the part J rear axle, then slide in the axle.
Slide a part I gear box onto the axle and route the wires from the gear box through the body of the car
and into the seat.
Slide on a part G rear wheel and replace the nut/washer to secure the wheel. Repeat on the other side.
Snap on two part H hub caps.
Remove the nuts/washers from the front axle.
Slide a washer and part F front wheel onto the axle, then replace
the nut/washer to secure the wheel. Repeat on the other side.
Snap on two part H hub caps.
2
3
Use the provided
plastic spanner to
tighten the nuts.
R L
B
F F
G G
H
H H
H
I
I
J
To Next Page
Loading...
