EasyManua.ls Logo

Bcube A8 Plus - Page 49

Bcube A8 Plus
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
48
B OPERATING INSTRUCTIONS
INERACTIVE TRAINING (OPTIONAL)
Fitness devices equipped with Bluetooth technology can be connected to compatible fitness apps. The "Kinomap" and
"Fitshow" programs are currently available for iOS and Android
1. Download the desired app to your mobile device
2. Register according to the specifications of the respective app
3. Activate Bluetooth in the settings of your mobile device
4. Switch on your fitness device
5. Open the corresponding app
6. Select your device type
7. Select the brand of your fitness device
8. Select the PROGRAM of your fitness device
9. Connect the device to your mobile device via the app
PROBLEMS AND REMEDIES
PROBLEM
POSSIBLE CAUSES
REMEDY
The treadmill will not
start
Power cable is not plugged in
Plug in the mains cable
The On/Off switch is not set to On
Set the on/off switch to On
The house fuse has jumped out
Check the house fuses
The cable in the right-hand upright has sheared
off at the top or bottom
Check the cable connection using the assembly instructions
The emergency stop safety key is not positioned
correctly on the console
Remove and reposition the emergency stop safety key
The fuse of the device is defective
Replace the fuse of the device
The connection cable from the controller to the
console has become detached from the controller
Check the plug connection on the controller in the engine
compartment
Transformer is not connected correctly or is
defective
Check transformer in engine compartment and replace if
necessary
The treadmill suddenly
stops
The motor switches off due to overload
Check the lubrication and tension of the running mat as
described in the assembly instructions
Electronics problem
Check power supply as described above
The treadmill jerks
when running
Running mat is too loose and slips through
Readjust the running mat tension as described in the
assembly instructions
The treadmill does not
run in the center
The treadmill is not correctly aligned
Center the running mat as described in the assembly
instructions
Treadmill squeaks
without load (without
runner)
Motor drive belt does not run centrally on pulley
of front idler pulley
Aligning the drive belt
Drive belt defective Replacing the drive belt