EN
31
WARNING! The straps should never be twisted. The
harness buckle must be fastened correctly and the
straps should t the child snugly.
LED SCREEN FUNCTIONING
he LED screen indicates whether the child restraint
system has been installed correctly, helping you to
follow the correct steps to install the seat as well as
guiding you if any of the control settings are wrong.
1f. The screen checks the following points:
Seat rotation
The seat has 2 functioning positions, forward facing
or rear facing, and 2 loading positions (passenger side
or driver side).
The loading positions are not suitable for use while
travelling, therefore the screen will indicate that the
position is incorrect by displaying an ”X”.
ISOFIX connectors
The seat is tted with 2 ISOFIX connectors. The
screen will indicate whether the connectors are
correctly secured (see the important note in the seat
installation section).
Support leg indicator
This symbol conrms that the leg position is correct
and that it is in contact with the oor.
If all the indicators display a“ “ then the word OK
will be displayed to conrm that the seat has been
installed correctly.
Changing the batteries
To change the batteries for the installation system
there is a compartment (13) on the underneath of
the seat base.
The system uses 2 x LR6 AA 1.5v batteries. Change
the batteries whenever the low battery warning
To Next Page
Loading...
