30
2b. Turn the seat until you feel it lock into the loading
position ready for the child to be placed in it (perpen-
dicular to the forward facing position).
Press the button (8) again to place the seat in the
forward facing position.
.
3. STRAPPING THE CHILD INTO THE
SEAT
This child restraint system has a loading position
making it easy to place the child in the seat and
adjust the straps to t correctly.
3a. Turn the seat to the loading position (2b) and
open the harness (5). Move the harness straps to the
sides to place the child in the seat.
3b. Place the straps over the child and fasten the
buckle.
3c. To adjust the headrest (2) pull the lever (1) on the
top. It should be set to the right position, this means
that the shoulder harness should come out approxi-
mately 1 cm above the child’s shoulders.
3d. Tighten the harness by pulling the strap (6), it
should t the child snugly.
3f. Once the child is securely strapped in, you can
tilt the seat by pressing the lever (7) to the required
position.
Getting the child out of the seat.
To get the child out of the seat, you should rst place
the seat in the loading position (2b).
IM 2205,01 APOLLO _ NO LED print.indd 30 19/4/21 17:03
To Next Page
Loading...
