35
2.7 If connect Wi-Fi failure, please try to reset WIFI module and connect it
again.
Note: Every time reset the Wi-Fi, must wait about 10 seconds, then the screen
will display “CF” or “AP” 5 times.
Note: There will be switch between “CF” and “AP” mode if reset the WIFI
module.
Add device
3-AP mode
3.1 Reset Wi-Fi
There are three methods to reset the WIFI module.
A: Press the “FAN” button on the control panel 6 times within 4 seconds;
B: Hold the “ON/OFF” button on the control panel about 5 seconds;
C: Hold the “Mode” button on the control panel about 3 seconds.
Please wait about 10 seconds, until the LED screen show “AP”, and connect
it again.
Note: Applicable to BC7KL\ BC9KL2201SSA+ \ BC9KL2202SSA+ \
BC12KL2201FWA+ \ BC14KL2201FW \ BC16KL2201FW models without B
and C options.
Note: The original state of the newly bought unit is in CF mode. If you choose
to use AP mode, please reset the Wi-Fi module and wait about 10 seconds
until the LED screen show “AP”, then start to connect it.
3.2 Click " " in the upper right corner of the "Home" screen or tap "Add
device" on the room which has no device.
To Next Page
Loading...
