33
Open the ap on the back of the seat and stow the
shoulder sections of the harness behind.
4.2- IMPORTANT: The support leg is not needed for
the 100 - 145cm conguration, raise it so that it does
not touch the oor of the vehicle.
STRAPPING THE CHILD INTO THESEAT
4.3- With the child in the seat pull the seat belt
around the front, locating it into both seat belt lap
section guides (7).
Pass the shoulder section through the diagonal
section seat belt guide(3).
Fasten the seat belt buckle and pull the seat belt tight,
removing any slack.
7. RECLINING THE CAR SEAT
5.1- The car seat has 3 recline positions to offer the
best comfort.
To recline the seat pull the recline lever and pull the
seat forward or backwards until reaching the required
position.
When using the seat in the rearward facing
position, from 40-105 cm.
5.2- The seat should be fully reclined before rotate to
rearward facing, only the position 1 is allowed.
When use the seat in the forward facing position,
from 76-145 cm.
5.3- Once the child is securely strapped in, you can
recline the seat by pressing the button (9) to the
required position, all the 3 positions are allowed.
5.4- You can adjust the angle of the seat when in
the forward facing position or when in the loading
position. YOU CANNOT adjust the angle of the car seat
when it is in the rearward facing position.
IM 2289,00 STAR INST.indd 33 14/6/21 13:07
To Next Page
Loading...
