Micro Marble Fireplaces
INSTALLATION INSTRUCTIONS AND USER GUIDE
M
A
D
E
I
N
B
R
I
T
A
I
N
M
A
D
E
I
N
B
R
I
T
A
I
N
Important Information
Before you begin the installation, please ensure that a full and detailed inspection of all component parts is
undertaken jointly by the installer and purchaser to ensure there is no damage or manufacturing defects with the
product. Once the fireplace has been installed, no claims or responsibility will be accepted by the manufacturer
relating to chips, scratches or any other obvious defects.
Please also ensure you carefully read and fully understand these instructions before commencing installation as
we cannot accept responsibility for any damage or defects caused by non-compliance with these instructions.
These instructions are written in accordance with the ‘Stone Federation Great Britain’ guidance on fire surround
standard building practice, Building Regulations (Approved Document J) and all relevant British Standards.
This fireplace should be installed only by competent professional fireplace installers and fitted only to suitable
surfaces. You should check with your installer that the constructional elements of the intended chimney breast
and flue comply with current Building Regulations, and that they are suitable for the appliance that is to be
installed.
NOTE: Installation is not recommended as a DIY or single person task. In addition to this giving rise to the
potentially increased risk of product damage and/or incorrect installation, it should also be noted that some
marble components can be very heavy and will require two people to lift/handle. Caution should always be
exercised if attempting to lift heavy or awkward objects.
Following the installation, please leave these instructions with the householder.
To Next Page
Need help?
General
