BEA IXIO-D CAN - 7 SETUP; FACTORY RESET; Quick Setup Procedure; Assisted Setup Procedure; Factory Reset Procedure

6
+
> > > >
1
2
A
B
> > >
0 1 2 3 4 5 6 7 8 9
< 2.8 m > 2.8 m
> > > > >>
+
+
+
2 s
4 s
7
WW NN
WW
WW
NN
NN
WN
NW
NN
NN
RADAR FIELDSIZE
RADAR IMMUNITY
RADAR DIRECTION
RADAR HOLDTIME
IR IMMUNITY
IR FREQUENCY
IR NUMBER
IR PRESENCE TIME
IR WIDTH
REDIRECTION
OVERVIEW OF SETTINGS
not allowed when the sensor is used in emergency exits
excludes conformity of the door system according to EN 16005 /
DIN 18650 / BS 7036. IR Immunity on values 4 or 5 is
incompatible with IR presence time on value 0
factory value
small large
bi uni
uni
AWAY
bi
shop
uni
shop
PRM
shop
low
uni
PRM
PRM: for persons with reduced mobility
AWAY: unidirectional motion away from sensor
auto: automatic adaptation of field size (small shops)
high
radar
off
0.5 s 1 s 2 s 3 s 4 s 5 s 6 s 7 s 8 s 9 s
Always additionally adjust
the arrow position on the
sensor with a screwdriver.
≥ 2,8 m : 6 + 7 (EN 16005)
≥ 2,2 m : 6 + 7 (BS 7036)
Sensors mounted close to each other need a different frequency.
motion
motion
or
presence
motion
and
presence
opening output is active in case of: 0 motion detection
1 motion or presence detection
2 motion and presence detection
low
normal
highnormal
high
higher
highest
service mode = no IR detection during 15 minutes (maintenance).
This value excludes conformity of the door system to EN 16005 and DIN 18650.
min. value for DIN18650: 1 min
min. value for EN16005: 30 s
service
mode
motion 15 s 30 s 1 min 2 min 5 min 10 min 20 min 60 min infinite
SETUP 1 (QUICK)
SETUP 2 (ASSISTED)
STEP OUT OF THE INFRARED FIELD!
reference picture
test of full door cycle +
reference picture
SETUP / FACTORY RESET
complete reset to factory values
FACTORY RESET