Beaba MULTI MILK N6T - Operating Programs and Modes; Precautions and Initial Setup

14
15
PRECAUTIONS
• Wash your hands well before handling your baby’s products and food.
• Always use the appliance on a stable and even surface.
• Do not place the appliance near a heat source, hotplates, etc.
• Do not move the appliance or cover it when in use.
• Before preparing a bottle, consult a healthcare professional or your pediatrician
for further information about food safety and preparation (water to use, storage,
preparation method, etc.).
• Also refer to the instructions supplied with your milk for any specic
recommendations.
• The temperatures indicated are for information purposes. Before feeding your
baby, check the temperature of the food by pouring a few drops onto the inside
of your wrist.
• You can stop the cycle at any time by pressing again on the ON/OFF button or
other button, but you can’t restart the cycle after stopping it.
COMPONENTS
PROGRAMS OPERATION
STARTING UP OF APPLIANCE
1. Plug the appliance into an earthed 220-240V socket.
2. Before the 1st use, it is recommended to launch a Steam fast cycle for 5 min
- Pour 40ml of water into the unit.
- Close the lid and press the “steam fast” button.
1
2
3
4
a
b
c
d
e
f
g
h
i
Lid
Lift-out basket
Bottle warmer body
Control panel
Temperature indicator
Time indicator
Setting button +/-
Water bath mode button
Baby jar mode button
Sterilize mode button
Defrost mode button
Steam fast mode button
ON/OFF button
PRODUCT : CONTROL PANEL :