17
Bottle type
Initial
temperature
Volume of milk or water
60 ml 120 ml 180 ml 240 ml
Glass
Fridge 2 min 3 min 3,5 min 4,5 min
Room 1,5 min 2,5 min 3 min 3,5 min
Plastic
Fridge 3,5 min 4 min 5 min 5 min
Room 2,5 min 3 min 3,5 min 4 min
* These recommendations are based on the test with the use of the BEABA wide-
neck glass bottle and the 2-in-1 training plastic bottle.
Note :
- Heating time varies with different brands of bottles and materials. The volume
of milk/water to be heated has also a signicant impact. If the bottle is not hot
enough, put it back in the appliance and restart the Steam Fast mode to heat
again for few minutes.
- After preparation, the bottle should be consume within 30 min. Discard any
unnished baby bottle, and do not reheat a second time.
BABY JAR MODE
The Baby Jar mode is for heating gradually the baby food.
1. Pour water into the bottle warmer (level max).
2. Place the baby food container and lift-out basket into the bottle warmer.
Note : for small capacity baby jars, put the container rst et then add water
3. Press the ON/OFF button.
4. Press the Baby Jar mode button.
5. When the time indicator ashes, press the setting button +/- to choose the
working time (1-59 mins). The default time is 30 mins.
6. The bottle warmer will start working after the temp/time indicator ashes
twice. The Babyjar mode button keeps ashing.
BE CAREFUL, RISK OF BURNING
During the heating, stir the baby food
to make sure that it is heated evenly.
7. The bottle warmer will beep 5 times at the end of countdown.
Always check that the temperature of the baby food is not too high and that
there is no risk of burning your child.
To Next Page
Loading...
