EasyManua.ls Logo

Bear DFB-B30S1 - Page 13

Bear DFB-B30S1
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
2
、清洗保温板板:打开煲盖,取下可拆保温板用清水将保温板清洗干并用干布擦干,用
干水的湿布将密封圈擦干,再将可拆保温板装回原位
(
注意:勿拉密封圈,如拉扯变
会影密封与微效果
)
2. Cleaning the insulation board: open the cover of the pot, remove the detachable insulation
board, clean the insulation board with clean water and dry it with dry soft cloth, dry the sealing
ring with a wet cloth that has been wrung out of water, and then install the removable
insulation board back to its original position (Note: do not pull the sealing ring, such as pulling
deformation will affect the sealing and micro pressure effect).
3
、清洗内:取出内,用柔的海清洗清洗后用干布将水擦干
3. Cleaning the inner pot: take out the inner pot, clean it with a soft sponge, and then dry the
water with a dry soft cloth.
(
注意:不可用钢丝球擦洗,否损伤不粘涂层
)
(Note: do not scrub with steel ball, otherwise the non stick coating will be damaged. )
4
、清洁电热盘:如果有粒或其他物附着在电热盘上,可
320
物磨掉,并
用干布擦干。
4. Clean the electric heating plate: if there are rice grains or other foreign matters attached to
the electric heating plate, use 320
fine sandpaper to grind off the sundries and dry them with
a dry soft cloth.
5
、外及上盖用干水的湿布轻轻擦拭即可,切勿使用汽油或其它溶液,也不可用水冲洗
或将品浸入水或其它液体中,以免坏。
5. The shell and upper cover can be gently wiped with a wet cloth that has been wrung out of
water. Do not use gasoline or other solutions, and do not wash with water or immerse the
product in water or other liquids to avoid product damage.