14 9 INCH CHIPPER
FEATURES & CONTROLS
Shutdown Alarm Icons:
Shutdown alarms are latching and immediately stop the engine. The alarm condition must be rectied before a resetting.
The alarm must be accepted and cleared, and the fault removed to reset the module. If the alarm condition remains, it
is not possible to reset the unit (The exception to this is the Low Oil Pressure alarm, as the oil pressure is low with the
engine at rest).
Shutdown Alarm Icons
Fail to Start The engine has failed to start after the congured number of start attempts.
Low Oil Pressure The controller detects the engine oil pressure is low after the Safety On Timer expired.
High Coolant
Temperature
The controller detects the engine collant temperature is high after the Safety On Timer
expired.
Over Speed The engine speed has risen above the over speed alarm setting.
Charge Failure The auxiliary charge alternator voltage is low as measured from the W/L terminal.
Emergency Stop
The emergency stop button has been depressed. This failsafe (normally closed to
emergency stop) input and immediately stops the set when the signal is removed.
Magnetic Pick-
Up Failure
Pulses are no longer being detected from the magnetic pickup probe.
To Next Page
Loading...