BEARWARE 302547 - Commissioning; DCF Signal

70 English
5. Commissioning
Take the product out of the package and remove all the packaging material. Open
the baery compartment of the outdoor sensor and insert two 1.5V AA baeries.
Then open the baery compartment on the back of the main unit and insert two
1.5V AA baeries. Alternavely, you can use the supplied 5V/150mA coaxial power
adapter for operaon. For this purpose, plug the mains adapter into a properly
installed socket and then connect it to the coaxial connector of the main unit.
Note: If you want to use the device with baeries, then the backlight is
not permanently switched on. The backlight of the display is connuously
switched on only when operated with the enclosed power adapter.
The weather staon then aempts to establish connecon with the outdoor sen-
sor. Make sure that both devices are within each other's range. The connecon
symbol " " ashes in the "Outdoor temperature display" of the main unit. If the
main unit cannot establish a connecon with the outdoor sensor within 3 minutes,
then it stops searching. The connecon icon stops ashing and the temperature
display shows "-._°C" and "-._%" on the display.
In most cases, the connecon cannot be established due to specic factors such
as reinforced walls or a too great distance between the sensor and the main unit.
In this case, posion the sensor and the main unit closer to each other. To restart
scanning, press and hold the "CH" buon on the back of the main unit for 3 sec-
onds unl the connecon symbol in the display starts ashing.
6. DCF signal
The DCF signal is a me signal which is sent out by one of the most accurate clocks
in the world. It is located near Frankfurt am Main. Under ideal condions, your
weather staon can receive this signal from a distance of up to 1500 km.
If the weather staon has detected the signal, then it displays Central European
Time, the date, and the day of the week. The DCF symbol " " is then shown in
the display.