BEARWARE 302547 - Stored Data; Maximum and Minimum Temperatures; Atmospheric Pressure History; Additional Settings

79English
9. Stored data
Maximum and minimum temperatures
Press the "MEM" buon to view the maximum indoor and outdoor temperatures
as well as the maximum humidity. The respecve maximum readings are now
shown on the display. Press the "MEM" buon again to view the minimum meas-
ured values. Aer 5 seconds, the current reading is displayed.
Note: The min/max temperatures are measured from the total operang
me of the weather staon. Press and hold the "MEM" buon for about 3
seconds to delete the stored maximum/minimum values.
Atmospheric pressure
By pressing the "SET/HISTORY" buon briey and repeatedly, you can view the
atmospheric pressure of the last 12 hours. The number in the "HIST" display
indicates the hour.
10. Addional sengs
DCF signal
The base staon synchronises the internal clock every night with the DCF signal.
To receive the DCF signal manually, press and hold the "DOWN" buon for 3
seconds, unl the following symbol appears in the display and ashes: “ ”. When
the signal is received successfully, the symbol will glow connuously. If the signal
is not received, the symbol disappears.
Receiving the signal external sensor
The outdoor sensor sends a signal twice a minute, which is automacally received
by the base staon. You can also manually enable the signal recepon. To do this,
press and hold the "CH" buon for about 3 seconds unl the channel symbol ("
") starts ashing. Once the signal has been successfully received, the anima-
on of the symbol disappears and the received temperature and humidity is
shown on the display of the weather staon.