BEARWARE 302547 - Alarm Setting; Setting and Enabling Alarms; Switching Off Alarms

78 English
8.2 Alarm seng
The weather staon can store up to 2 alarm sengs, which can be turned on and
o separately.
Seng the alarm
Press and hold the "ALARM/SET" buon for about 3 seconds to access the alarm
sengs. The alarm me is now displayed instead of the me. You can make the
desired sengs using the "UP" and "DOWN" buons. Then press the "ALARM/
SET" buon again to save the alarm seng. You can congure these sengs using
Alarm 1 (A1) and Alarm 2 (A2).
Enabling the alarm
Press the "DOWN" buon in me mode. An alarm icon is subsequently displayed
next to the me. This means that the alarm is enabled. To disable alarm 1 and to
enable alarm 2, press the "DOWN" buon again. Pressing the "DOWN" buon
again enables alarm 1 and alarm 2. Both alarm symbols are shown in the display.
Both are disabled by pressing the "DOWN" buon again. The symbols then
disappear from the display.
Switching o the alarm
When the alarm is acvated at the congured me, the backlight also turns on
automacally. The alarm is acve for 2 minutes before it turns o automacally.
Press the "SNOOZE/LIGHT" buon to cancel the alarm. If a snooze symbol is
shown on the display, this means that the snooze funcon is acvated and the
alarm will go o again in 5 minutes.
Press any buon to switch o the alarm.