BEARWARE 302547 - Temperature Alarm

77English
from the local weather report. Please note that the data has to be
entered into the weather staon.
• Atmospheric pressure unit - The default seng in Europe is the
unit "hPa". Alternavely, you can set the unit "inHg".
8.1 Temperature alarm
You have the opon to dene a temperature range for the outdoor sensor. With
the temperature alarm, the base staon will emit an alarm sound if the outdoor
sensor measures anything outside this temperature range.
Press and hold the "ALERT" buon at the back of the base staon for about 3
seconds. The temperature display starts ashing. The following symbol starts
ashing " ".
Then press the "UP" or the "DOWN" buon to select the maximum temperature
of the desired range. Conrm the value by pressing the "ALERT" buon. The "
" symbol starts ashing in the temperature display. By pressing the "UP" and
"DOWN" buons, you can now select the minimum value of the desired tempera-
ture range. Conrm again by pressing the "ALERT" buon. The temperature alarm
is now ready for use.
Press the "ALERT" buon now to enable or disable the temperature alarm. If the
temperature alarm is enabled, the symbol " " appears in the display.
If the outdoor sensor measures a temperature outside the previously congured
range, an alarm is emied for about one minute from the base staon. This alarm
can be muted by pressing a corresponding buon on the weather staon. The
temperature which triggered the alarm will start ashing in the display. Press the
"ALERT" buon to switch the alarm o.