BEARWARE 302547 - Basic Settings; Language and Time Settings; Time Zone Configuration; Weather Forecast Setup

76 English
8. Basic sengs:
Note: Firmly touching the top of the housing will switch on the backlight.
Aer the "SNOOZE/SLEEP" buon is released, it switches o again aer 5
seconds. Please note that the base staon does not respond to 2 buons at
the same me. It is therefore advisable to press only one buon.
Press and hold the "SET/HISTORY" buon for about 3 seconds to congure the
basic sengs. With the "UP" and "DOWN" buons, you can change the values
accordingly.
By briey pressing the "SET/HISTORY" buon in the me sengs, you can conrm
entry and proceed to the next opon. In this way, you can change and customise
the following sengs in the sequence menoned below:
• Year
• Month
• Day
• Language seng - To set the day on the display. The following
codes can be congured and selected using the "UP" and "DOWN"
buons: GE (German), DA (Danish), ES (Spanish), NE (Dutch), FR
(French), IT (Italian), EN (English)
• 12 or 24 hour display
• Hour
• Minute
• Time zone - Note: If you set the me zone, for example, to + 01
and the weather staon is actuated using the DCF-signal, then the
clock displays one hour later than the DCF-signal.
• Weather forecast - The weather staon calculates a weather
forecast based on changes in the air pressure. Since data regard-
ing changes in air pressure is not available when the device is
switched on for the rst me, the weather forecast at this me is
incidental. The weather staon will be able to calculate a forecast
only aer a couple of days. To do this, select a forecast using the
"UP" and "DOWN" buons. It is best to select a forecast from the
current weather report.
• Atmospheric pressure - The atmospheric pressure is displayed
in "mb" or "hPa" depending on the seng. You can now set the
display to the barometric air pressure of your locaon. Use the
atmospheric pressure data of your locaon from the Internet or