BEARWARE 302658 - Alarm Setting; Radio Signal

11English
6.2 Alarm seng
Press the "alarm" buon in me mode to acvate the alarm. The alarm symbol
appears on the display once the alarm is acvated.
Press and hold the "Alarm" buon for 2 seconds to access the alarm sengs.
The sengs can be adjusted using the "UP" and "DOWN" buons. Conrm the
respecve seng using the "Alarm" buon. The seng sequence is as follows:
Hour - Minute
The alarm symbol on the display starts ashing once the audible alarm is heard.
The audible alarm has several levels:
0-10 seconds alarm: 1 beep
10-20 seconds alarm: 2 beeps
20-30 seconds alarm: 3 beeps
30 seconds - 2 minutes alarm: connuous beep
If the alarm is not turned o within 2 minutes, it switches o automacally.
Press the "Snooze/light" buon during the alarm to acvate the Snooze mode
and to temporarily turn o the alarm. The alarm is turned o for about 5 minutes
and then goes o again. A snooze symbol appears on the display when the snooze
mode is acve.
Press any buon (except the "Snooze/light" buon) to turn o the alarm. The
alarm will be enabled again on the next day at the congured me, unless you
turn o the alarm using the "Alarm" buon and the alarm symbol is no longer
shown in the display.
6.3 Radio signal
Press the "wave"buon to enable or disable the radio search mode. The radio
symbol appears on the display when the search mode is enabled.
The radio alarm clock searches for a signal every day at 1:00, 2:00, 3:00, 4:00 and
5:00 a.m.
Once the daylight saving me (DST) is received, a "DST" symbol appears in the
display.