BEARWARE 303457 - Page 29

29English
2. Press the "ALERT" buon to switch between the "HI" and "LO" temperature
channels.
3. Press the "CHANNEL / +" buon or the "MEM / -" buon to change the
value.
4. To set the temperature value "Hi" or "Lo", press the "ALARM" buon at the
top of the weather staon to turn the HI / LO alarm on or o.
5. Once you nish, press and hold the "ALERT" buon for about 2 seconds.
The display changes back to the me mode. Alternavely, the device
automacally returns to the me mode aer about 60 seconds aer the
last buon is pressed.
6. The seng sequence: Channel --> "Hi" temperature alarm --> "Lo" temper-
ature alarm --> Channel
When the alarm is acvated, it can be heard audibly and the icon ashes on the
display. Press the "ALARM / SNOOOZE", "ALARM" or "ALARM" buon to stop the
alarm. If you ignore the alarm, it stops aer 2 minutes.
Note: You cannot enter contradictory HI / LO values in the seng. If the HI tem-
perature value, for example, is 40° C, you cannot set the LO alarm to more than
39.9 °C, etc.
When an alarm is acvated in Auto Cycle mode, the display switches to the
corresponding channel. You can press "ALARM / SNOOZE", "ALARM" or "ALERT".
Alternavely, the alarm stops automacally aer 2 minutes. The display returns to
Auto Cycle mode.