BEARWARE 303530 - Data Logging and Learning Mode

27English
9. Stored data
Maximum and minimum temperatures
Press the "UP" buon to view the maximum indoor and outdoor temperatures as
well as the maximum humidity. "max" appears on the display. Press the "UP" but-
ton again to view the minimum measured values. "min" appears on the display.
Aer about 15 seconds, the current reading is displayed.
Note: The min/max temperatures are measured from the total operang me of
the weather staon. Press and hold the "UP" buon for about 3 seconds to delete
the stored maximum/minimum values.
Atmospheric pressure
The atmospheric pressure is automacally measured every hour and shown in the
display. The table shows the approximate trend of the atmospheric pressure.
10. Addional sengs
14 day Learning mode
Whenever you do an electrical reset (remove baeries from the baery com-
partment and disconnect the mains adapter), the weather staon will switch to
a 14-day learning mode to ensure a more accurate weather forecast trend. As
long as the weather staon is in the learning mode, "Learning ..." is shown in the
display above the weather forecast.
Receiving the outdoor sensor signal
The outdoor sensor sends a signal twice per minute, which is automacally
received by the base staon. You can also manually enable the signal recepon.
Press the "CHANNEL" buon repeatedly unl you reach the channel that was se-
lected using the switch in the baery compartment of the corresponding outdoor
sensor. Alternavely, you can also acvate the automac channel switching. Here,
the weather staon switches through all the channels, even through the ones not
used by the external sensors.