BEARWARE 303530 - Alarm Setting Configuration

26 English
8.3 Alarm seng
The weather staon can store up to 2 alarm sengs, which can be turned on and
o separately.
Seng the alarm
1. Press the "MODE" buon two mes in the default screen to access the
alarm mode. Only the alarm me is shown in the display.
2. Press and hold the "SET" buon in alarm mode for 2-3 seconds unl the
alarm me starts to ash.
3. Press the "UP" and "DOWN" buons to congure the values. Conrm the
entry using the "SET" buon. Once you have congured ALARM 1, you have
to congure ALARM 2 as well. Conrm your entry again by pressing the
"SET" buon.
Enabling the alarm
Press the "ALARM" buon in the default screen. An alarm icon is subsequently
displayed above the current me. This means that the alarm is turned on. To
disable alarm 1 and to enable alarm 2, press the "ALARM" buon again. Pressing
the "ALARM" buon again enables alarm 1 and alarm 2. Both alarm symbols are
shown in the display.
Both are disabled by pressing the "ALARM" buon again. The symbols then
disappear from the display.
Switching o the alarm
The alarm is acvated at the congured me. The alarm is acve for 2 minutes
and 30 seconds before it turns o automacally.
Press the "SNOOZE/LIGHT" buon to cancel the alarm. If a snooze symbol is
shown on the display, this means that the snooze funcon is acvated and the
alarm will go o again in 5 minutes.
Press any buon to switch o the alarm.