BEARWARE 304273 - Page 27

27English
Atmospheric pressure
The atmospheric pressure is automacally measured every hour and shown in
the display. The table shows the approximate trend of the atmospheric pressure.
10. Addional sengs
DCF signal
The base staon synchronises the internal clock every night with the DCF signal. To
receive the DCF signal manually, press and hold the "DOWN" buon for 3 seconds,
unl the following symbol appears in the display and ashes: “ ”.
When the signal is received successfully, the symbol will glow connuously. If the
signal is not received, the symbol disappears again.
Receiving the outdoor sensor signal
The outdoor sensor sends a signal twice a minute, which is automacally received
by the base staon. You can also manually enable the signal recepon. To do this,
press and hold the "CHANNEL" buon for about 3 seconds unl the channel sym-
bol (" ") starts ashing. Once the signal has been successfully received, the
animaon of the symbol disappears and the received temperature and humidity
is shown on the display of the weather staon.
Switching the keypad tones on and o
Press the "UP" buon in the default screen for about 3 seconds to turn the
keypad tones o. The entry is conrmed with a beep.
Cauon!
11. Safety instrucons and disclaimer
Never try to open the device to repair or make modicaons. Avoid contact with
the mains voltage. Do not short-circuit the product. The device is not waterproof,
hence please use it only in dry surroundings. Protect it from high humidity, water
and snow. Keep the device away from high temperatures.