BEARWARE 304273 - Page 26

26 English
Enabling the alarm
Press the "UP" buon in the default screen. An alarm icon is subsequently
displayed next to the me. This means that the alarm is enabled. To disable alarm
1 and to enable alarm 2, press the "ALARM" buon again. Pressing the "ALARM"
buon again enables alarm 1 and alarm 2. Both alarm symbols are shown in the
display.
Both are disabled by pressing the "ALARM" buon again. The symbols disappear
from the display.
Cauon! Make sure that you have previously selected the desired days (1-5 and /
or 6-7) in alarm mode.
Switching o the alarm
When the alarm is acvated at the congured me, the backlight also turns on
automacally. The alarm is acve for 2 minutes before it turns o automacally.
Press the "SNOOZE/LIGHT" buon to cancel the alarm. A snooze icon is shown in
the display. This means that the snooze funcon is acvated and the alarm will go
o again in 5 minutes.
Press any buon to switch o the alarm.
9. Stored data
Maximum and minimum temperatures
Press the "MAX/MIN" buon to view the maximum indoor and outdoor temper-
ature, the maximum humidity, the maximum and minimum air pressure. "max"
appears on the display. Press the "MAX/MIN" buon again to view the minimum
measured values. "MIN" or "MAX" is shown in the display. Aer about 6-7 sec-
onds, the current reading is displayed again.
Note: The min/max temperatures are measured from the total operang me of
the weather staon. Press and hold the "MAX/MIN" buon for about 3 seconds to
delete the stored maximum/minimum outdoor temperature readings.