BEARWARE 304304 - Initial Setup and Use

26 English
5. Inial use
1. Take the product out of the package and remove all the packaging material.
Open the baery compartment of the outdoor sensor and insert two 1.5V
AA baeries. Pay aenon to the correct polarity of the contacts.
2. Determine the channel number of the outdoor sensor.
3. Then press the "RCC" buon in the baery compartment of the outdoor
sensor to receive the radio-controlled me signal (DCF). Then close the bat-
tery compartment.
4. Now open the baery compartment of the backup baery at the boom of
the weather staon and insert a CR2032 baery. Pay aenon to the correct
polarity of the contacts.
5. Then, connect the provided 5V DC coaxial power adapter to the weather
staon.
6. For this purpose, connect the power adapter to a properly installed socket.
Note: The CR2032 baery is used only as a backup baery and supplies pow-
er to the internal memory so that all sengs are saved.
This wireless sensor can receive the radio-controlled clock signal for automac
me synchronizaon of the main unit.
To use this funcon, the sensor must be connected only to the main unit. Once the
channel is assigned to a wireless thermal hygroscope sensor, you can change this
only by removing the baeries or by reseng the device.
Do not place the sensor in direct sunlight, rain or snow.
To prevent the connecon between the wireless sensor and the main unit from
disconnecng, rst switch on the sensors, and then press the RESET buon in the
main unit aer seng up the sensors.
You may not receive the signal immediately. The best recepon is oen during
the night due to atmospheric disturbances.