BEARWARE 304304 - Barometric Pressure Settings; Adjusting Relative Atmospheric Pressure

33English
7.8 Barometric/atmospheric pressure
When the alarm me or date is displayed, press the "BARO" buon on the back
of the weather staon to display the barometric air pressure value.
Press the "BARO" buon again to change the unit between inHg/mmHg/hPa.
If the air pressure value is displayed, press and hold the "BARO" buon for about
2 seconds to change between the units. The unit ashes in the display above the
air pressure value:
(ABS) Absolute: the absolute atmospheric pressure at your locaon
(REL) Relave: the relave atmospheric pressure based on sea level
Adjusng the relave atmospheric pressure value
You can now set the display to the barometric air pressure of your locaon.
Use the atmospheric pressure data of your locaon from the Internet or from
the local weather report. Please note that the data has to be entered into the
weather staon.
1. Press and hold the "BARO" buon for 2 seconds unl the "ABS" or "REL"
symbol starts to ash.
2. Press the "CH/+" or "MEM/-" buon to change to relave mode (REL).
3. Press "BARO" buon again unl the digit for the relave air pressure begins
to ash.
4. Press the "CH/+" or the "MEM/-" buon to change the value.
5. Press the Baro buon to save and exit the seng mode.
Note: The default value of the relave atmospheric pressure is 1013 hPa (29.92
inHg), which refers to the average atmospheric pressure. If you change the value
of relave air pressure, the weather indicators also change. The relave atmo-
spheric pressure is based on the sea level. However, it changes with the absolute
atmospheric change in pressure.