Set up and use your Solo
3
Wireless
headphones
Here's everything you need to know to make the most of your Solo
3
Wireless headphones.
1. Turn on
Press and hold the power button for about a second to turn your headphones on or off.
2. Set up
Follow these steps if you have an iPhone using iOS 10. When you set up your
headphones in this way, they set up automatically with your other devices that are signed
in to iCloud and using iOS 10, macOS Sierra or watchOS 3.
1. Hold your headphones next to your unlocked iPhone.
2. Press the power button on your headphones for 1 second.
3. After a few seconds, your iPhone asks you to connect. If it doesn't, press the power
button on your headphones for 5 seconds.
4. Follow the instructions on your iPhone.
If you have another Bluetooth device, follow these steps to pair your headphones to that
device:
5. Press the power button for 5 seconds. When the fuel gauge flashes, your headphones
are discoverable.
6. Go to Bluetooth settings on your device.
7. Select your headphones from the list of discovered Bluetooth devices.
3. Connect to a different device
Your headphones automatically reconnect to the last device you used with them. To
connect to a different device, follow these steps.
For iPhone X using iOS 11 or later:
1. Open Control Centre by swiping down from the top-right corner of the screen.
2. The audio card appears. Tap the AirPlay icon in the top-right corner of the card, then
choose your headphones from the list of playback devices.
To Next Page
Need help?
General
