o Press and release the volume up button, or press and hold to increase volume
continuously.
o Press and release volume down button, or press and hold to decrease volume
continuously.
To control phone calls, use b on the left earcup, or the center button on the RemoteTalk
cable.
o To answer or end a call, press once.
o To answer a second incoming call and put the first call on hold, press once. When two
calls are active, this switches between calls.
o To reject an incoming call, press and hold for 1 second.
o To stop listening through your headphones and send the call to the phone, press twice.
To activate Siri on your iOS device or the voice-command feature on another device, use
b on the left earcup, or the center button on the RemoteTalk cable. Press and hold until
you hear a chime, then say what you need.
To check the Fuel Gauge, which shows battery level and charging status, tap the power
button.
To turn Pure ANC off, double-press the power button while connected to your device. To
turn Pure ANC back on, repeat this process. Pure ANC enables each time you power on
your Beats Studio
3
Wireless, reducing external noise during playback.
6. Reset
0. Hold down the power button and volume down button for 10 seconds.
1. When the Fuel Gauge flashes, release the buttons.
Your headphones are now reset and ready to be set up with your devices again.
7. Update
Your headphones are automatically kept up to date when they're set up with an iPhone
using iOS 11.
If your headphones aren't paired with an iPhone using iOS 11, you can use the Beats
firmware updater
8. Charge
To Next Page
Loading...
