BEAULIEU 4008 - Page 22

Position of the pointer needle:
— Within the notch: exposure satisfactory.
— Above the notch: risk of overexposure.
— Below the notch: risk of underexposure.
Important
In all cases, the viewfinder needle should lie within the notch.
If it does not, two possible reasons exist:
— either too much light: film with the shutter half-closed, not for-
getting to divide by 2 the film sensitivity value set on the film-
speed dial;
— or not enough light: choose a faster emulsion or, if the subject
permits, work at a slower filming speed.
For remote-control filming, you must:
— set the camera on a tripod;
— lock the power supply switch in the continuous position "C" ;
— set the release button to the "continuous" position and use one
of the remote-control devices.
8* Manual use of the diaphragm
After setting the master switch to "Manuel", sight the subject to be
filmed, and bring the pointer needle in the viewfinder opposite
the mark by rotating the diaphragm setting ring. The Beaulieu is
ready to film.
If lighting conditions on the subject vary, rotate the ring to keep the
needle within the notch.
In order to disconnect the automatic action of the Reglomatic, just
set the master switch to "Manuel" and proceed as for non-automatic
22