BEAULIEU 4008 - TOLEN Unloading the Camera

Switch O' drives it towards the wide-angle position.
The time for, extreme changes in focal lengths is from about 2 secs.
to about 35 secs. /Z
The adjustment ring O merely has to be set accordingly.
When the master switch is set to "Manuel", zoom control also
becomes manual.
11° Unloading the camera
In Beaulieu cameras, the end of the film is shown by the cessation
of the flicker-indicator in the lower part of the viewfinder. Open
the side door and take out the cartridge. The word "exposed"
should appear on the film itself; this is a certain identification of an
exposed film, and avoids re-loading the camera with an already-
exposed film.
CAUTION. - When removing a partly-exposed cartridge, 7 frames are
fogged and the footage counter automatically returns to 15 m/50 ft.
If it is imperative that cartridges should be changed the length
of unexposed film still available should be noted on the label in
such a position that it can be read through the side-door window
when the film comes to be loaded once more.
This figure will allow the operator to correct the footage counter's
indications and to be certain of the amount of film still unexposed.
IMPORTANT. - After filming, make quite certain the power-supply
switch is in position A (normal). Never leave this switch in position C
when not in use: you would run the risk of completely discharging
the battery. This switch should permanently be kept in positions A
or B both of which automatically interrupt the battery power
circuit.
24