Customer ServiceTroubleshooting TipsOperating InstructionsSafety Instructions
9
Loading and using the washer.
Always follow fabric manufacturer’s care label when laundering.
Cleaning the Fabric Softener Dispenser (on some models)
Remove the dispenser from the top of the agitator.
Separate the dispenser cup from the cover by grasping the top and pushing down on
the inside of the cup with your fingers. Dispenser cup will pop free from the cover.
To clean the dispenser, soak both the dispenser cup and the dispenser cover in the
following solution:
■
1 US gallon (3.8 liters) warm water
■
1/4 cup (60 ml) heavy duty liquid detergent
■
1 cup (240 ml) bleach
If necessary, loosen build-up with a clean, soft cloth after soaking. Do not use a stiff
brush; you may roughen the surface of the dispenser.
Rinse and reassemble dispenser. Place dispenser back on the agitator.
5
4
3
2
1
Separate for cleaning.
Sorting Wash Loads
Proper Use of Detergent
Add detergent and start the washer before adding
clothes so that the detergent can work effectively.
Using too little or too much detergent is a common
cause of laundry problems.
You can use less detergent if you have soft water, a
smaller load, or a lightly soiled load.
Loading the Washer
Load dry items loosely, no higher than the top
row of holes in the washer tub. When loading wet
items make sure you set the load/water level high
enough to allow the items to move freely. Water
level should just cover the clothes. To add items
after washer has started, push in Cycle Dial and
submerge additional items next to the agitator.
Close the lid and pull Cycle Dial out to restart.
■
Do not wrap large items like sheets around the
agitator.
■
Do not wash fabrics containing flammable
materials (waxes, cleaning fluids, etc.).
■
Agitation will not start with the lid up.
Colors
Whites
Lights
Darks
Soil
Heavy
Normal
Light
Fabric
Delicates
Easy Care
Sturdy Cottons
Lint
Lint Producers
Lint Collectors
To Next Page
Loading...