EasyManuals Logo

BEC 7800TN User Manual

BEC 7800TN
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
Configuring a BEC 7800TN
Wireless ADSL Modem
Setting Up the PC | Logging into BEC | Configuring Wireless
Setup | Setup – Static IP
Setup – Main Port | Finished | Firmware Update
ATTENTION!
Before the modem is programmed and installed for the first time, it must have the latest
firmware on it. This can be found by logging into the modem per the instructions below.
On the “Device Info” page find “Software Version”, this should be 2.02e.RC3-dss3. If it is
not, the firmware will need to be update before proceeding.
See Page 14 of this document for instructions on flashing new firmware to the modem.
Setting Up the PC
Before you can get into your new BEC 7800TN Wireless modem, you will need to have the computer's Ethernet interface
to be set up for DHCP, or you will have to set up a static IP address.
Use the following address information if setting up a static IP in the computer's Ethernet interface:
IP ADDRESS: 192.168.10.100
SUBNET MASK: 255.255.255.0
GATEWAY: 192.168.10.1
PRIMARY DNS: 216.129.224.1
SECONDARY DNS: 216.220.0.1
Back to Top

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BEC 7800TN and is the answer not in the manual?

BEC 7800TN Specifications

General IconGeneral
BrandBEC
Model7800TN
CategoryNetwork Router
LanguageEnglish

Related product manuals