Becken Comando - Entering Code Manually; Manual Search Without Code; Clock Setting Function

12
B. Entering code manually
1. Turn on your air conditioning manually.
2. Look for your appliance’s brand in the
code table.
3. Press and hold (3 seconds) the “SET”
button until the code numbers ash on
the LCD screen. Press the Temperature
buttons (button 13) to adjust the code on
the LCD screen, the numbers will ash.
4. Press the OK button when the
corresponding code appears and the air
conditioning emits a sound.
5. If everything works correctly, it means
that your remote control is properly set.
If not, repeat the previous steps with
another code.
C. Manual search without code
1. Turn on your air conditioning manually
and point the remote control at the
appliance’s receiver.
2. Press the “SET” button (for 3 seconds)
or until the signal on the control’s LCD
screen ashes.
3. Release the “SET” button and the
control will search for the correct code
automatically.
4. As soon as your air conditioning emits a
sound, press “OK” and the control is set.
D. Clock setting function
Press the CLOCK button (14) (about 3
seconds) to enter clock mode, the clock
on the LCD screen will ash. Use the
temperature buttons (13) to adjust the time.
Press the OK button to set the desired time.