Electrical installation
Synchronous servomotor24 Version: 2.1
iTec extension cable
Connecting the plug connection
Align the two plug connector (1) and (2) such
that the white marking point (3) and the area
(4) line up. Push the two plug connectors
together in the direction of the arrow. Ensure
that the black locking ring (5) can turn freely.
Press the two plug connectors together until
the locking point is reached.
Note!:
When the connector engages, a “click” sound
can be heard. This indicates that the
components were installed correctly.
If the connector does not engage
automatically, manually turn the white marking
point into the correct position.
To disconnect the plug connection
Hold the plug connector (2), turn the black
locking ring (1) downwards in the direction of
the arrow and hold it in this position. Now pull
the plug connector (2) apart to the left in the
direction of the arrow.
To Next Page
Loading...