Error handling and diagnostics
Embedded PC 43
when the boot project was
created
14 pulses
n
nth Bus Terminal has the
wrong format
Start the power supply again, and if the error occurs
again then exchange the Bus Terminal.
15 pulses
n
Number of Bus Terminals is
no longer correct
Start the power supply up again.
16 pulses
n
Length of the K-Bus data is
no longer correct
Start the power supply up again.
Error code argument
The number of pulses indicates the position of the last Bus Terminal before the fault. Passive Bus Terminals, such as
a power feed terminal, are not included in the count.
In the case of some errors, rectification does not cause the power supply to leave the blink sequence. The power
supply can only be restarted by switching its supply voltage off and on again.
To Next Page
Loading...
Need help?
General
