Page 1
9487 Dielman Rock Island Industrial Dr. St. Louis, MO 63132 Tel:(314) 567-0088
Operator's Manual Rev: D08
TABLE OF CONTENTS
Firmware Version......................................................1
Environmental Conditions.........................................2
Electrical Specifications ............................................2
Warnings....................................................................3
Section A: Programming the Controller...................4
A – 1: The Program Menu........................................4
A – 1.1: Entering the Program Menu................4
A – 1.2: Selecting Language.............................4
A – 1.3: pH High Alarm Point..........................4
A – 1.4: pH Low Alarm Point...........................4
A – 1.5: ORP High Alarm Point.......................4
A – 1.6: ORP Low Alarm Point........................4
A – 1.7: ORP/ppm............................................4
A – 1.8: Exiting the Menu ................................4
Section B: Normal Operation ...................................5
B – 1: Displaying the Set points ...........................5
B – 2: Modifying the Set Points ...........................5
B – 2.1: Modifying the pH Set Point ................5
B – 2.2: Modifying the ORP Set Point .............5
B – 2.3: Modifying the ppm Set Point..............5
B – 2.4: Modifying the Booster Trigger Point..5
B – 2.5: Modifying the Booster End Point .......5
B – 3: Single Point Calibration.............................5
B – 3.1: Single Point Calibration - pH..............5
B – 3.2: Single Point Calibration - ppm............5
B – 3.3: Probe Error..........................................6
B – 4: Alarms........................................................6
B – 4.1: pH High/Low alarms...........................6
B – 4.2: ORP High/Low alarms........................6
B – 4.4: No Flow alarm ....................................6
B – 4.5: (x) min Feed Delay .............................6
B – 4.6: Cl/Br Lockout .....................................6
B – 4.7: pH FAILSAFE ALM..........................6
B – 4.8: Cl/Br FAILSAFE................................6
B – 4.9: Booster FAILSAFE ............................6
B – 5: Resetting a Failsafe Alarm.........................6
Section C: Maintenance............................................7
C – 1: Potentiometric Sensors (pH and ORP).......7
C – 1.1: Electrode Cleaning:.............................7
C – 1.2: Long-Term Storage:............................7
Section D: Feed Charts.............................................8
D – 1: Spa Feed Charts.........................................8
D – 2: Pool Feed Charts........................................9
Section E: Installation Diagrams ............................10
E – 1: Pressure Filter Installation........................10
E – 2: Vacuum Filter Installation........................10
Section F: Warranty................................................11
Firmware Version
This manual was written for firmware v1.20. If you received newer firmware but did not receive a copy of the manual
covering that version of firmware, please contact your distributor.
To Next Page
Loading...
Need help?
General