1
HEADBOARD
DC Power Cord
2
Make the bed completely flat
with a flipping motion
.
3
DC Power Cord
HEADBOARD
Set up the adjustable base with the bed frame and slat base.
Take the bed out of the box, put it on the slat base and
do not
install
any legs. Uncoil the DC power cord (connected to the control
box) and pull the DC power cord toward the direction of the AC power
source
through either the bottom or the side of the bed frame.
Insert the flat mattress retainer bar into the securing strap at the bottom of
the BEDGEAR mattress, and then snap it into the mattress retainer mounts.
Installation method 1:
(Exclusively for BEDGEAR Mattresses)
2
1
one side after another for non-BEDGEAR mattresses.
Alternatively, install the mattress retainer bar
Installation method 2:
- 6 -
To Next Page
Loading...