bednest cot - If You Have a ‘Divan’ or Solid Based Bed

12
How to use in bednesting mode cont. :
If you have a ‘divan’ or solid based bed
Wrap the long strap around the base of your bed, underneath the mattress, so that the
‘D’ ring is at the side of the bed where you wish to attach the bednest. Take the short
strap and unthread it from its clip. Put the short strap through the ‘D’ ring and re-thread
its clip, taking care to thread correctly so that it can be tensioned.
Loop the free ends of the short strap around the middle carry-handle of the stand and
snap the clip shut, then set the height of the stand to be 3 to 5cm (1 or 2 inches) below
the top of your own mattress.
Adjust the straps so there is no slack, but do not overtighten, as this could cause the
bednest to tilt.
The bednest stand is now firmly held to the side of your bed.