Congratulations on choosing the finest interior flooring kit available for your Jeep.
BedRug material is mold and mildew resistant, easily cleaned with water & household
cleaning chemicals and extremely resistant to most chemicals.
Driver side wheel well, passenger
side wheel well, rear cargo area floor, tailgate piece,
hardware kit, and instruction sheet.
Utility knife, soap, water and
rubbing alcohol.
PreParation
1. Read all instructions before beginning installation.
2. Remove rear seat and old Jeep flooring material.
3. Wash and dry the floor pan and wheel well areas thoroughly.
4. Cut the hook with tape backing, provided in the hardware kit, to the lengths indicated on drawing (page 5).
Place the loop onto each location. Do not remove the tape backing at this time.
(Note: Cut the longest pieces first.)
Jeep floor should be at least 68°F (20°C) for maximum adhesion. Clean all areas with rubbing
alcohol before applying tape. When removing backing, do not touch adhesive. If both front and rear kits
were purchased be sure to install rear cargo area first. The BedRug product is designed to work with most
factory tub layouts. If the Jeep has any aftermarket accessories or custom parts such as seats brackets or
roll bars you may need to trim our product to fit.
installing tHe WHeel Wells
5. Fit driver side wheel well piece into place (Fig. 1), markings on
back of part indicate where to make cuts for roll bar, and rear seat
bracket (if equipped). Be sure to cut only markings necessary for
your Jeep. (See drawing on page 5).
6. Start at the rear of vehicle, making sure to line up bottom edge to
the floor and back edge tight to the rear flange. (Fig. 2 and Fig. 3)
Clean surface with alcohol then remove the film backing and roll
the part back into place. Firmly press the top surface to ensure
adhesive attachment.
7. If your wheel well piece has fastener along the top edge, pull down
the top of the wheel well piece to access the hook fastener. Clean
the surface with alcohol then remove the film backing and roll the
part back into place. Firmly press the top surface to ensure
adhesive attachment.
BEDRUG, INC.
n
635 Old Hickory Blvd, Old Hickory, TN 37138-3162
n
800-462-8435
n
bedrug.com
Jeep Wrangler CJ-7/YJ BedRug
Interior Installation Instructions
CJ-7
YJ
BRCJ76R
BRCJ81R
BRYJ87R
REAR KITS:
To Next Page
Need help?
General
