4
3
Join the Top Pole and Braces
You will need:
Parts as assembled in Step 1 & 2
Top Pole (part 6 - W)
2 x Bolts, Nuts & Washers B (M12 x 160mm)
Making sure the Top Pole is the right way round (highest hole must be furthest from backboard), x the ends of
the Backboard Braces (parts 4 & 5) to the Top Pole (part 6 - W) using two Bolts, Nuts and Washers B. Again, don’t
overtighten - follow our tip in Step 2 to ensure the braces can move (very important for adjusting the height of the
backboard).
4
You will need:
Parts as assembled in Step 1, 2 & 3
Adjustment Pole (part 9 - Z)
Adjustment Handle (part R)
Middle Pole (part 7 - X)
Bracket (part Q) - and metal plates (parts L1 & L2)
1 x Bolt, Nut & Washers A (M12 x 160mm)
1 x Bolt, Nut & Washers G (M10 x 110mm)
2 x Bolts, Nuts & Washers H (M8 x 130mm)
a. Attach the Adjustment Pole (part 9 - Z) to the free hole at the end of the Board Brace (part 5 - T) using one Bolt,
Nut and Washers A.
b. Add the Adjustment Handle (part R) to the bottom of the Adjustment Pole (part 9)
c. Attach the Middle Pole (part 7) to the top pole using one Bolt, Nut & Washer G.
d. Attach Bracket (part Q) to the middle pole using two Bolts, Nuts & Washers H and the two rectangular metal
plates (parts L1 and L2).
Add the Adjustment Pole and Middle Pole
To Next Page
Loading...
