13
Temperature control
1. The default 3-gear temperature is started, the red light at the bottom is turned on, and the
temperature can be adjusted by short press (DS-A23 has 0-12 gears, and gear 0 is to turn off the
heating function).
2. When the temperature of DS-A23 reaches the ninth gear, the colour of the temperature indicator
starts to change into a colourful light and flashes, The higher the temperature, the faster the change
speed of the colourful lamp
3. When the temperature reaches the highest gear, short press again to turn off the heating function
(gear 0), and the temperature indicator goes out, the red light at the bottom goes out
Pressure relief / pause
DS-A23: during cupping, if you want to stop or remove the product, briefly press this key to pause
cupping. The tank adsorption function and pressure relief can easily lift the tank and enter the
standby state.
Note: 1. When using this machine with liquid peripheral products such as essential oil, please be sure
to keep the essential oil on the skin after the skin surface is evenly coated and there is no obvious
liquid, adsorb the machine to the required position.
2. The machine is designed with a filter device, which can filter out most of the particles in the
process of product use or liquid impurities to protect the internal cleaning of the fuselage and
maintain the service life of the product. Please use it according to your personal needs Frequency,
check and replace the filter cotton regularly.
Charging instructions
1. Connect the type-C charging cable to the adapter socket, and connect the
other end to the product charging interface to start charging Electricity Adapter side SV2= 2A
3. Please keep the type C charging port dry and clean during charging. The charging time will vary
slightly due to environmental conditions Subject to the actual time. Do not charge for more than 8
hours. During charging, the white indicator flashes and goes out after being fury charged
4 The product cannot be used when it is charged
To Next Page
Loading...