12
Operational guidelines
Preparation before use
1. Please read the safety precautions carefully when using this product, if it does not meet the
use conditions, this product is disabled a product
2. It is recommended to clean and moisturize the skin with a wet towel or spray to improve the
sense of use experience.
3. Tighten and install the transparent tank (wipe the instrument with a wet towel before and
after use).
4. Check whether the instrument is complete and normal
Power / mode
1. Press and hold for 1.5 seconds to start the machine, the LCD displays the 20-minute countdown,
and the temperature indicator lights up. The machine is equipped at 20-minute timing and
automatically shuts down after 20 minutes!
2. Press and hold for 1.5 seconds to shut down, and the LCD and temperature indicator will go out.
3. In the power on state, short press to change the mode. The machine has two modes, deep
negative pressure mode and soothing mode breathing pattern.
4. The default start-up mode is deep negative pressure mode, and the
negative pressure function and heating function are automatically turned on
Suction Strength
1. The power on defaults to the third gear strength.
2. Short press to adjust the suction strength (DS-A23 has 0-12 gears, 0 gear is off (negative pressure
function)
3. Each short press will increase 1 gear upward, and the LCD will display the corresponding strength
gear, after 1 second it will display the 20 minutes countdown.
4. When the intensity reaches the highest gear, short press again to return to gear 0 and turn off the
negative pressure function.
5. It is recommended to use it from gear 1 for the first time or when the skin is not adapted.
To Next Page
Loading...