Beechcraft Bonanza - User Manual

Before beginning construction of your Bonanza you should make these following corrections:
Fuselage Plan The correct site of the rudder/fintip block (BON9S08) is: 5/8" x 7/8' x 6-1/4'
Page
57, step 7 - Change F2 to F1 A.
Page 57, step 9 - Change F2 to F1A.
Page
58, step 17 - Change ". .along the cut lines . ." to ". .about l/l6" inside the cut lines. "
Page 58, step 2 - Change ".. Phillips head . to . Socket Head Cap Screw. ."
Page 60, step 4 - Change 1" x 1-3/4"X2" -3/8' x 1-3/8' x 1-1/2'
Page
62, step 15 - Change Fuselage to "cowl "
Page 64, step (wing)l - Add " as " after the word " such "
Page 68, step 10 - Add sure " after the word " make "
Page 69, control throw chart - Trim mixing section change references to " Down " to " Up "

Summary

TOP FLITE BEECHCRAFT BONANZA ADDENDUM

INTRODUCTION

PRECAUTIONS

DECISIONS YOU MUST MAKE

TAIL CONFIGURATION

Explains the choice between V-tail and straight tail configurations.

ENGINE SELECTION

Provides guidance on selecting the appropriate engine size and type.

RETRACTABLE LANDING GEAR

Discusses the option of installing retractable versus fixed landing gear.

FLAPS

Describes the function and optional installation of model flaps.

TOP FLITE SCALE ACCESSORIES

OPERATIONAL LIGHTING

Details the optional operational lighting system for the model.

SCALE COCKPIT INTERIOR

Describes the optional scale cockpit interior kit for enhanced detail.

OTHER ITEMS REQUIRED

ACCESSORIES

Details specific accessories required for model assembly and operation.

BUILDING SUPPLIES

Lists necessary glues, fillers, and other building supplies.

NOTES FROM THE DESIGNER

GET READY TO BUILD

BUILD THE TAIL SURFACES

Instructions for constructing the tail surfaces of the model.

BUILD THE WING

Instructions for constructing the wing panels of the model.

BUILD THE FUSELAGE

Detailed steps for constructing the main body of the aircraft model.

Beechcraft Bonanza Specifications

General

Brand	Beechcraft
Model	Bonanza
Category	Toy
Language	English