UK
CARE AND MAINTENANCE
• Check regularly the walker frame for signs of damage or wear. Clean the plastic
parts, including the stoppers, with a damp cloth.
• Clean the seat with brush or family soap and neutral scour. Dry the metal parts to
prevent the formation of rust. Prolonged exposure to direct sunlight may cause the
fabric to fade.
FITTING AND/OR REPLACLNG BATTERLES
WARNING! The toy of the walker frame requires 2X"AA" 1.5Volt alkaline type
batteries (not included)
Batteries must only be fitted by an adult.
• To fit and/or replace batteries: loosen the screw on the battery compartment cover
with a suitable screwdriver, press the tab and remove the battery compartment cover.
Then remove the spent batteries and fit new ones, ensuring that they have been
fitted in the correct polarity, as shown inside the battery compartment. Replace the
battery cover and tighten the screws.
• Always keep batteries and tools out of reach of children.
• Always remove spent batteries from the toy to avoid the danger of possible leakage
from the battery damaging the product.
• Always remove the batteries if the toy will not be used for a long period.
• Only use alkaline batteries of the same type of equivalent to the type recommended
for the correct function of this product.
• Never mix new and old batteries, or different types of batteries.
• Do not burn or dispose of spent batteries into the environment. Dispose of spent
batteries at an appropriate differentiated collection point.
• Do not short-circuit the battery terminals.
• Do not attempt to recharge non-rechargeable batteries: they might explode.
• The use of rechargeable batteries is not recommended and cannot be used.
8
To Next Page
Loading...